Ramsey Winch FORD GRILL GUARD KIT 295374 (PAT 12/15) - Manual (Page 2)

DO NOT FULLY TIGHTEN HARDWARE UNTIL LATER!
1. Attach (1) nut plate (item #3) loosely to inside of L.H.
mounting bracket (item #1) using (2) 1/2-13NC X 1.25
capscrews (item #10), (2) flat washers (item #14), and
(2) lockwashers (item #13). See figure at right. Repeat
for R.H. Mounting Bracket (item #2).
2. Remove vehicle tow hooks. Discard existing hardware.
3. Remove L.H. vehicle bumper bracket bolts (2 bolts).
Secure L.H. mounting bracket to vehicle frame using (1)
nutplate (item #4), (2) 1/2-13NC x 1.75 capscrews (item
#9), (2) flat washers (item #14), (2) lockwashers (item
#13), and (2) nuts (item #12). These nutplates go to the
backside of the frame flange. The flat washers go over the
slotted holes in the mounting bracket. NOTE: The other
pair of nutplates are installed at the end of the installation
(see step 12).
Hint: To align holes between mounting bracket, bumper
bracket, and frame, you may need to raise or lower the
bumper slightly.
4. Install (3) 1/2-13NC x 1.50 capscrews (Item #8) and (3)
lockwashers (Item #13) through underside of vehicle
frame and into nutplate (Item #3).
5. Repeat for R.H. mounting bracket.
6. Install tow hooks into the ends of the R.H. and L.H.
mounting brackets using (3 per side) M12x1.75x 30mm
capscrews (Item #11) and 1/2” lockwashers (Item #13).
Install tow hooks pointing downward.
Outside mounting
holes in brackets
are slotted
2