Ramsey Winch FORD GRILL GUARD KIT 295340 - Manual (Page 4)

STEP 2
3
Enlarge rectangular cutout in bumper bracket by 3/4" at top and 1/4" at bottom, as shown below in
REAR VIEW OF BUMPER Attach nut plate (item #4) to inside of each bracket assembly (items #7 &
#8) using (2) 1/2-13NC x 1-1/4 lg. capscrews with lockwashers and flatwashers, each side. While
holding bumper in place, install end of R.H. and L.H. bracket assemblies through bumper and
bumper brackets and into ends of R.H. and L.H. vehicle frame. Make sure that slotted mounting
holes on R.H. and L.H. brackets are to the outside. Secure brackets to front of frame using (2) 1/2-
13NC x 1-1/2 lg. capscrews with lockwashers, nuts, and nut strip (item #1), each side. DO NOT
TIGHTEN HARDWARE COMPLETELY.