Ramsey Winch DODGE GRILL GUARD KIT 295930 - Manual (Page 2)

Note: It is not necessary to remove the airdam in order
to modify it or install the kit. The following pictures
show the airdam removed for clarity only.
1. Cut notches in air dam for the Lower Mounting Brackets to
fit through. Cut 1/2” wide notches from the bottom of the
top lip of the air dam, cutting through the bottom lip of the
air dam. As shown below, the spacing of the notches is 16
3/16” from center to outside of notch. The best way to
measure the center of the air dam is to measure from the
License Plate mounting bolt holes. Find the center between
the holes, and mark it as your center of the air dam.
The 1/2” width of the notch does not allow any clearance
of the bracket that fits through it. You may need to trim it
slightly after you have the bracket installed, but you will
want the fit as tight as possible.
2. Remove factory bolt assembly and discard.
2
312
1
2
1
2
16 3
16
16 3
16
Air dam
License Plate
Mounting Holes
Cut Notch
Here