Ramsey Winch CHEVY WRAPAROUND KIT 295932 - Manual (Page 3)

2
Step 3
Drill 17/32” hole in vehicle frame using rear hole in frame mounting bracket as a template (Figure 6).
Install 1/2" nut #22 through existing access hole in bottom of vehicle frame (Figure 7). Using a
standard combination wrench to hold the nut in place, thread (1) 1/2-13NC X 1-1/4" capscrew #19
into nut (Figure 8).
DO NOT TIGHTEN HARDWARE COMPLETELY.
Step 4
Note: It is not necessary to remove the vehicle bumper to install this kit. Install upper mounting
bracket #11 (Figure 9 and 10) on bumper using 3/8 X 1" bolt #17. Secure using 3/8" locknut #21
(Figure 10). Make sure top tab of left hand bracket is pointed toward the left side of vehicle (Figure
11).
Do not tighten hardware completely.
Repeat Steps 1-4 for right side of truck.
Figure 6 Figure 7 Figure 8