Ramsey Winch CHEVY WRAPAROUND KIT 295362 (RE WINCH) - Manual (Page 3)

KI-913358-0200-A 2
Step 4
Repeat Step 1 through Step 3 for right hand side of vehicle. Tighten hardware to the appropriate
torque value (See Torque Value Chart on page 5).
Step 5
Remove shipping strap and mounting bolts from
winch assembly and discard. Place frame assembly
#2 over top of winch and secure. Use (3) 3/8-16NC
x 1” hex head capscrews #9 with lockwashers #19
and (1) 3/8-16NC x ¾” socket head capscrew #14
with 9/16” high collar lockwasher #20 to attach
winch to rear angle of frame assembly (Figure 4). DO
NOT TIGHTEN.
Attach winch to front angle of frame assembly using
(3) 3/8-16NC x 1” socket head capscrews #13 with
high collar lockwashers (9/16 OD) #20 and (1) 3/8-
16NC x ¾” socket head capscrew #14 with 9/16”
high collar lockwasher #20 as shown in Figure 4.
Note: The (2) outer-most capscrews are inserted
through holes in face of mounting frame and threaded
into winch. The (2) inner-most capscrews are placed
through fairlead opening and threaded into winch.
Tighten front hardware to appropriate torque
value, then tighten back hardware (See Torque
Value Chart on page 5). Snap hole plugs #25 into outer-most holes in front of frame assembly.
Step 6
NOTE: YOU WILL NEED ASSISTANCE FOR THIS STEP.
Have someone hold the winch and mounting frame #2 between the left and right brackets. Position
left-hand side plate assembly #1 at the outside of the winch mounting frame (Figure 5). Insert (3) 1/2-
13NC x 1-1/2” carriage bolts #11 through the holes in side plate #1, through frame mounting bracket
#5, and through the mounting frame. Secure using (1) lockwasher #21 and nut #18 for each carriage
bolt. Do not tighten completely. Repeat for the right hand side plate.
Figure 5
Figure 4