Ramsey Winch CHEVY WRAPAROUND & GRILL GUARD KITS 295934 & 295935 - Manual (Page 4)

3
Note: If you are installing Grille Guard kit #295934, skip Step #7 and proceed
to step #8. Step 7 is for the Wraparound Kit only.
Step 7
Position the wrap shim #31 and the L.H. wraparound #4 with the headlight grille #28 next to the side
plate and align holes. Insert (2) 1/4-20NC x 1-1/4 capscrews #16 through side plate, wrap shim,
wraparound, and headlight grille and secure using 1/4 nuts #20. Do not tighten.
Insert (3) 1/4-20NC x 1
capscrews through holes
above and below headlight
grille #12 and secure using
1/4 nuts #20.
Repeat for right hand side.
Tighten all nuts to proper
torque.
Step 8
Properly align the assembly with the front of the vehicle. Starting with the lower mounting brackets
and working up, tighten all hardware to proper torque. Refer to Torque Table on page 5 for proper
torque values.
If needed, install License Plate Mounting Assembly to bottom of channel using (2) 1/4 x 1” capscrews
#14 and 1/4” locknuts #19. Refer to winch Owner’s Manual for instructions for installing winch and
fairlead using hardware supplied with winch.
Figure 6