Ramsey Winch RPH-45000 (Foot Mtd.) - Manual (Page 4)

1
LAYER OF CABLE
(Kgs.)..............................................................................20,380
* These specifications are based on recommended wire rope of .75 inch
dia. extra improved plow steel or equivalent
Gear Reduction................................................................................51.35:1
Weight (without cable)....................................................689 lb. (313 Kgs.)
*Rated line pull
per layer
(at 25 GPM)
*Cable capacity
** Last layer does not conform to SAE J706
*Line speed
75
22
37,700
27
8.2
17,100
MPM 7.0
Lbs.
Kg.
45,000
20,380
FPM
Ft.
M.
35
10
23
9.8 11.0 12.2
125 180 245
74
32,400 25,300
11,460
28,500
32 36 40
14,690
54 38
12,920
13.7
310
94
22,900
45
10,380
Rated Line Pull (lbs.).........................................................................45,000
6** 5 4 3 2 1
RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH 45,000
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and
safety procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until
you have carefully read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch
we make. If the need should arise, warranty procedure is outlined on the back of your self-addressed
postage paid warranty card. Please read and fill out the enclosed warranty card and send it to Ramsey
Winch Company. If you have any problems with our winch, please follow instructions for prompt service on
all warranty claims. Refer to back page for limited warranty.
SPECIFICATIONS*
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope
ratings.
WARNINGS:
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD. CABLE
ANCHOR IS NOT DESIGNED TO HOLD LOAD.