Ramsey Winch RPH-45000 (Foot Mtd.) - Manual (Page 13)

10
10. Set gasket #36 into place on gear housing end bearing #10. Place ring gear #49 onto end bearing,
aligning holes in ring gear with holes in gasket and gear housing end bearing. Use (2) capscrews
to temporarily secure ring gear to end bearing. Place (2) gear carrier assemblies into ring gear
meshing carrier gears with ring gear. Slide input sun gear over shifter shaft #11 and mesh with
teeth of input carrier. Apply grease to input thrust washer and place into slots of gearbox cover #4.
Place gasket #36 into position on gearbox cover with sealer. Remove (2) temporary capscrews
and attach cover and gasket to ring gear end bearing. Use (12) capscrews #15 to secure gearbox
to gear housing end bearing. Torque capscrews to 87 ft.-lbs. each, in a criss-cross pattern.
11. Pull rod from air cylinder as far as possible. Slide washer #26 over setscrew #21 and against nut
attached to air cylinder rod. Place setscrew into hole of shifter shaft #12 and attach air cylinder to
gearbox cover using (4) capscrews #23. Apply Loctite PST thread sealer to threads of
capscrews. Torque capscrews to 5 ft.-lbs. each, in criss-cross pattern.
12
21
26
27
39
34
37
31
23
47
36
4
49
12
15
14
10
36