Ramsey Winch OUTPUT CARRIER KIT FOR RPH 20000/25000 251250 - Manual (Page 4)

15. Place Gear Housing Cover onto Ring Gear by compress-
ing Clutch Spring while aligning gear teeth and bolt holes
with Ring Gear as shown at right.
16. Replace (8) Capscrews, torquing in a criss-cross pattern
to 18 ft-lbs. (24 Nm) each.
17. Apply Permatex to threads of Pipe Cap. Thread pipe cap
onto pipe nipple in bottom of Gear Housing End Bearing.
Pour approx. 1.75 pints of SAE 80W-140 oil into end
bearing. Check oil level by removing oil plug. Insert
Relief Fitting and Thread Reducer into end bearing at oil
fill hole.
18. Install winch and connect pressure lines.
19. Check proper operation of clutch by applying air pressure
to clutch air cylinder to disengage clutch. Verify that
winch drum freespools. Re-engage clutch. A loud noise
should be heard when clutch engages. Winch drum
should not freespool.
20. Operate winch forward and reverse to verify that drum
rotates.
914100-0902-A
Parts List
Item Part
No. Qty. No. Description
1 1 247030 Output Carrier Assembly
2 1 418435 Separator Washer
3 1 418443 Input Thrust Washer
4 1 462063 O-Ring
1
2
4
3
RAMSEY WINCH COMPANY
P.O. BOX 581510 TULSA, OK 74158-1510 USA
PHONE: (918) 438-2760 FAX: (918) 438-
visit us at http://www.ramsey.com
4
Oil Level
Plug
6688