Ramsey Winch PATRIOT 15000 BRAKE REPLACEMENT KIT 251252 - Manual (Page 2)

6. Lift Drum assembly from Gear Housing assembly.
Output sun gear should remain engaged with the intermediate output
shaft, but if it comes off with drum, as shown below, pull on it to
loosen, then replace it over the intermediate output shaft.
Once the output sun gear is removed, discard
the existing drum including the brake.
7. Remove input shaft from gear housing assem-
bly and set aside.
8. Refer to Kit Parts List on page 5 for new part
item numbers.
9. Examine gear housing seal on inside of gear
housing and replace if needed with item #4.
If replacing seal, cover with a thin film of
grease (use Mobilith SHC 007 synthetic
grease or use excess from the new prelubri-
cated drum assembly).
10. Take the new pre-lubricated drum assembly (item #3) and
place on the gear end, meshing the sun gear with the planetary
gears in the drum. Make sure the drum is fully seated and cen-
tered on the gear housing as shown at right.
2