Ramsey Winch ATV WIRELESS REMOTE FOR ATV User Manual

Page 6

NOTE: For clarification see wiring schematic on page 5.
1. Attach black with yellow stripe motor lead to lower right terminal stud

“B” on solenoid.

2. Attach black motor lead to lower left terminal stud “C” on solenoid .
3. Attach connector with 2 yellow wires to the terminal directly above the

black with yellow stripe motor lead.

4. Attach connector with 2 green wires to the terminal directly above the

black motor lead.

5. Attach black battery lead to upper left terminal stud “E” on solenoid.
6. Attach red battery lead to upper right terminal stud “A” on solenoid.

Connecting Wiring to Solenoid (unless motor and battery leads are
switched)

Installing the Solenoid

1. Mount solenoid in location determined previously.

2. Secure using (1) tube clamp, (1) #10-24 screw, (1) flat washer,

and (1) lock nut each side of solenoid assembly.

CAUTION: BE SURE THAT NO WIRE CONNECTIONS ARE IN
CONTACT WITH EITHER THE ATV FRAME OR WITH EACH
OTHER AS A DIRECT SHORT WILL OCCUR.

Installing the Toggle Switch

1. Route red, yellow and green wires to toggle switch location.

2. Drill 1/2” hole in location for toggle switch installation.

3. Insert switch through hole drilled in previous step.

4. Place directional plate over switch and secure using knurled nut.

Using wrench, tighten backup nut securely against inside of instru-
ment cover. Make sure directional plate is installed in the same
direction as the toggle switch movement.

5. Place rubber boot over switch and tighten securely.