Ramsey Winch ATV WIRELESS REMOTE FOR ATV - Manual (Page 10)

Trouble Shooting Guide
Correction
Turn transmitter on (See
Testing/Operation) .
Replace Battery.
In extremely cold tempera-
tures, keep transmitter in a
pocket of innermost layer
of clothing when not in
use.
Make sure receiver ground
wire has good connection
to ATV ground.
Program receiver (refer to
Programming the
Receiver).
Mount antenna at least 10
inches from winch motor
and battery leads.
Move the transmitter
around the ATV until nor-
mal operation resumes .
Keep transmitter in direct
line of sight with antenna
for optimal operation.
Stay within 50 ft. of anten-
na for optimal operation.
Make sure no similar
devices are within 50 ft. of
vehicle.
Make sure ATV battery
voltage is above 9.5 volts.
Possible Cause
Transmitter is off.
Low transmitter battery
voltage.
Transmitter temperature
below 0°F (-18°C).
Bad ground connection.
Receiver not coded with
transmitter.
Antenna mounted too
close to winch motor and
battery leads.
External environmental
conditions causing inter-
mittent operation in a
specific transmitter loca-
tion.
Signal deflecting off of
land mass or solid
structures.
Transmitter out of oper-
ating range.
Operating within 50 ft. of
any similar device.
Low ATV battery voltage.
Condition
Transmitter won’t
operate
Remote receiver will not
operate.
Intermittent operation.
7