Ramsey Winch ATV REPLACEMENT MINI ROCKER SWITCH FOR WIRELESS 256129 User Manual

Page 2

Before Beginning Installation

1. Disconnect negative (-) battery cable

from battery. Turn off vehicle ignition.

2. Disengage winch clutch.

3. Remove hood or cowling as necessary for

easier access to installation area.

4. Locate accessory wire from vehicle ignition

switch that is powered only when ignition is
ON. Use this wire when splicing to Red wire
on Rocker switch.

5. Make sure locations are close enough for

wiring connections to be made without mak-
ing alterations to wire lengths.

AUTION

: D

O NOT CONNECT NEGATIVE BATTERY

CABLE OR ENGAGE CLUTCH UNTIL INSTALLATION

IS COMPLETE

. W

INCH COULD BEGIN SPOOLING

CABLE UNEXPECTEDLY CAUSING INJURY OR

DAMAGE TO WINCH

Installing the Rocker Switch

For clarification, see wiring schematic on
page 1.

1. Install green Wire Connector (item #1-

12) to green wire on Rocker Switch (item
#2) and black Wire Connector (item #1-
13) to black wire on Rocker Switch, as
shown at right.

2. The Rocker Switch assembly (item #2)

will be assembled with the two halves of
the housing already attached. Install the
Mounting Bracket (item #1-2) using (2)
#6 screws (item #1-4) and shake-proof
washers (item #1-7). See figure below.
Tighten securely. Do not overtighten.

3. Install (2) Handle Bar Clamps (item #1-

3) around ATV handle bars at a conven-
ient location. Use a 3/4” long #10 screw
(item #1-5) and #10 locknut (item #1-
9) to secure them. See figures below and
at right. Secure loosely, do not tighten.

4. Install the Mounting Arm (item #1-1) to

the Handle Bar Clamps using a 7/8” long
#10 screw (item #1-6), shake-proof
washer (item #1-8), and locknut (item
#1-9). Install the shake-proof washer
between the handle bar clamps and the
mounting arm. See figures below. Do not
tighten.

5. Install the Mounting Bracket (with rocker

switch attached) to the Mounting Arm
Bracket using a 3/4” long #10 screw,
shake-proof washer, and locknut. Install
the shake-proof washer between the
mounting arm bracket and the mounting
bracket.

1-2

1-7

1-4

NOTE:

LONGER SCREW

1-5

1-6

1-9

1-11

1-1

1-5

1-3

1-11