Ramsey Winch ATV 2500 ROCKER SWITCH 256117 - Manual (Page 3)

11. Make sure wires are not drawn taut across
any surfaces that could damage them. Use
cable ties to anchor wires. Tie off excess.
Connect Wiring to Solenoid
C AUTION : T IGHTEN NUTS ON TERMINAL STUDS TO 35-40
IN - LBS . (3-4 N M ) TORQUE . D O NOT OVER - TIGHTEN .
For clarification, see wiring schematic on page 1.
1. Connect Red Battery Lead (Item #4-3)
between “A” terminal on Solenoid and positive
(+) vehicle battery terminal.
2. Connect Black Motor Lead (item #4-1)
between #2 terminal on motor and C termi-
nal on solenoid. Connect Black w/Yellow
Stripe Motor Lead (item #4-2) between #1
terminal on motor and B terminal on solenoid.
3. Connect Black Battery Lead (item #4-4) to
“E” terminal on Solenoid and route to nega-
tive (-) vehicle battery terminal but do not
connect.
4. Plug Yellow wire from switch into right termi-
nal (terminal above black with yellow stripe
motor lead). Plug Green wire from switch into
left terminal (terminal above black motor
lead).
Finish Installation
1. Confirm that winch clutch is disengaged.
2. Connect negative (-) battery cable to vehicle
battery. Connect Black Battery Lead from
winch to negative (-) vehicle battery terminal.
3. With ignition switch OFF, press Rocker switch
to “OUT”—winch should not operate. If the
winch does operate with the ignition off, con-
firm that proper accessory wire from ignition
was spliced.
4. Spool a few feet of cable out by hand. Engage
winch clutch.
5. Turn ignition switch ON and press Rocker
switch to “OUT”—winch should spool cable
out.
6. If winch does not operate with ignition on,
check wiring against the schematic on page
1.
7. If winch spools cable IN instead of OUT, turn
off ignition and reverse yellow and green
wires on solenoid.
3
PARTS LIST
ITEM
NO. QTY. PART NO. DESCRIPTION
1 1 257535 HARDWARE KIT
2 1 257536 ROCKER SWITCH KIT
3 1 299728 SWITCH WIRING KIT
4 1 299724 SOLENOID WIRING KIT
5 1 251234 SOLENOID KIT
3-Switch
Wiring Kit
4-Solenoid
Wiring Kit
5
3
4
2
1
3
1 2
4
3
9 8
1
5
4
11
12
6
10
2
7
1-Hardware
Kit
2