Ramsey Winch ATV 2500 ROCKER SWITCH 256117 User Manual
Page 2
C
AUTION
: D
O NOT CONNECT NEGATIVE BATTERY CABLE OR
ENGAGE CLUTCH UNTIL INSTALLATION IS COMPLETE
. W
INCH
COULD BEGIN SPOOLING CABLE UNEXPECTEDLY CAUSING
INJURY OR DAMAGE TO WINCH
.
Solenoid Mounting: Choose a mounting location
that will remain protected and dry (The best loca-
tion will usually be where the Solenoid for the
Remote Switch was located.) Solenoid must be
mounted within 24” of winch motor. Solenoid
should be mounted on a flat surface.
Installing the Solenoid
1. Use Solenoid Assembly as a guide to mark
and drill (2) 7/32” holes in location deter-
mined for solenoid.
2. Use (2) 3/4” long #10 capscrews (item #1-
3), (2) #10 flat washers (item #1-8), and
(2) #10 locknuts (item #1-5) to mount sole-
noid. Tighten to 60 in-lbs (7 Nm) torque.
Installing the Rocker Switch
For clarification, see wiring schematic on page 1.
1. Position Tube Clamp (item #1-11) on handle
bars in convenient location.
2. Mount Rocker Switch housing (item #2) to
Tube Clamp using #10 capscrew, locknut,
flat washer, and shake-proof washer (item
#1-3, #1-5, #1-8 and #1-9). Tighten
securely.
3. Push the Green, Red, and Yellow wires
through the back of the switch housing.
4. Install the Gasket onto the Rocker Switch.
5. Connect Yellow wire (item #3-3) to top ter-
minal on Rocker Switch (terminal behind “IN”
position). Connect Red wire (item #3-1) to
middle terminal on Rocker switch. Connect
Green wire (item #3-2) into bottom terminal
of Rocker switch.
6. Slide Green, Yellow, and Red wires into loom
(item #3-4). Slide loom up to back of the
switch housing.
7. Snap switch and switch housing together.
8. Push Accessory wire from ignition and other
end of Red wire into plastic Splice.
9. Fold splice clip over itself and snap closed.
10. Route wires from Rocker Switch down the
handle bars. Turn the handle bars fully right
and left to ensure plenty of clearance.
2
Mounting Hole
Pattern:
Two 7/32” holes
spaced 4.5” apart.