Ramsey Winch ATV 2500 ROCKER SWITCH FOR WIRELESS REMOTE 256118 - Manual (Page 3)

PARTS LIST
ITEM
NO. QTY. PART NO. DESCRIPTION
1 1 257539 HARDWARE KIT
2 1 257536 ROCKER SWITCH KIT
3 1 299728 SWITCH WIRING KIT
Hardware Kit, as shown at right, consists of the fol-
lowing components:
ITEM NO. QTY. DESCRIPTION
1-1 1 #10-24NC X 3/4 LG TRUSS
CR RECESS F/B CAPSCREW
1-2 1 #10-24NC HEX LOCK NUT
1-3 1 #10 Z/P FLAT WASHER
1-4 1 #10 SHAKE PROOF WASHER
1-5 1 PKG CABLE TIES (12 EA)
1-6 1 TUBE CLAMP
1-7 1 WIRE SPLICE
Switch Wiring Kit, as shown at right, consists of
the following components:
ITEM NO. QTY. DESCRIPTION
3-1 1 123” RED WIRE
3-2 1 123” GREEN WIRE
3-3 1 123” YELLOW WIRE
3-4 1 24” LOOM
3-Switch
Wiring Kit
3
4
2
1
3
1
5
4
6
2
7
1-Hardware
Kit
Finish Installation
1. Confirm that winch clutch is disengaged.
2. With ignition switch OFF, press Rocker switch
to “OUT”—winch should not operate. If the
winch does operate with the ignition off, con-
firm proper connections of the yellow, green,
and red wires. See Schematic on page 1.
3. Spool a few feet of cable out by hand. Engage
winch clutch.
4. Turn ignition switch ON and press Rocker
switch to “OUT”—winch should spool cable
out.
5. If winch does not operate with ignition on,
check wiring and confirm continuity between
the three wires from the Rocker Switch and
the corresponding wires at the wiring harness
connected to the receiver.
6. Make sure wires are not drawn taut
across any surfaces that could damage
them. Use cable ties to anchor wires. Tie off
excess.
3
2-Rocker Switch Kit