Ramsey Winch ATV 2500 ROCKER SWITCH FOR WIRELESS REMOTE 256118 User Manual

Page 2

Before Beginning Installation
1. Turn off vehicle ignition. Locate toggle

switch and the red, yellow, and green wires
connected to it. Confirm that toggle switch
will not operate winch and no power is going
to it.

2. Disengage winch clutch.
3. Remove hood or cowling as necessary for

easier access to installation area.

4. Cut off one of the spade connectors on the

supplied yellow and green wires (Items #3-2
and 3-3). Because wire splices will be used,
the spade connectors will not be needed.
NOTE: One spade connector at the end of
each of the yellow, green, and red wires
will be used to connect to the rocker
switch. Do not cut off both spade con-
nectors.

AUTION

: D

O NOT START VEHICLE IGNITION OR ENGAGE

CLUTCH UNTIL INSTALLATION IS COMPLETE

. W

INCH COULD

BEGIN SPOOLING CABLE UNEXPECTEDLY CAUSING INJURY OR
DAMAGE TO WINCH

Installing the Rocker Switch
For clarification, see wiring schematic on page 1.
1. Position Tube Clamp (item #1-6) on handle

bars in convenient location.

2. Mount Rocker Switch housing (item #2) to

Tube Clamp using #10 capscrew, locknut,
flat washer, and shake-proof washer (item
#1-1, #1-2, #1-3 and #1-4). Tighten
securely.

3. Push the Green, Red, and Yellow wires

through the back of the switch housing.

4. Install the Gasket onto the Rocker Switch.
5. Connect Yellow wire (item #3-3) to top ter-

minal on Rocker Switch (terminal behind “IN”
position). Connect Red wire (item #3-1) to
middle terminal on Rocker switch. Connect
Green wire (item #3-2) into bottom terminal
of Rocker switch.

6. Slide Green, Yellow, and Red wires into loom

(item #3-4). Slide loom up to back of the
switch housing.

7. Snap switch and switch housing together.

8. Route wires from Rocker Switch down the

handle bars. Turn the handle bars fully right
and left to ensure plenty of clearance.

9. Route wires to toggle switch and match yel-

low, green, and red wires from rocker switch
to the corresponding wires connected to the
toggle switch.

10. Place yellow wire from toggle switch and yel-

low wire from Rocker Switch into wire splice,
fold splice clip over itself and snap closed.
Repeat for the green and red wires.