Probuilt Professional Lighting Uplight v2 - Manual (Page 7)

1. Place Uplights in required position.
2. Connect each Uplight together starting with the one farthest from
the power supply. Make sure that the power supply power cord(s)
is / are out of harm’s way
3. Once all the Uplight’s are connected to each other, plug the
host light into the power supply and switch the supply ON.
LIGHTING TUBE REPLACEMENT
Ensure that only replacement lighting tubes of the correct type are used.
Uplight v2 is supplied with either an 18W (2ft) or a 36W (4ft) Philips 865 Colour Rendition
‘Cool Daylight’ T8 triphosphor tube.
1. Switch OFF Uplight v2 at the mains power supply and disconnect. Allow
adequate time for cooling.
2. Unscrew the lens cap and remove the lamp holder cover cap
from the lighting tube assembly by pulling it away gently in a vertical direction.
3. Lift the lighting tube out of the lighting tube assembly.
4. Place the new lighting tube into the lighting tube assembly
making sure that the two end-pins are correctly inserted
into the lower anti-shock tube buffer. DO NOT FORCE – CORRECT
INSERTION SHOULD BE STRAIGHTFORWARD.
5. Replace the electrical fitting, again making sure that the
end-pins are inserted securely into the upper anti-shock tube buffer.
6. Replace the lens cap ensuring a correct seal to prevent the ingress of water
or dust. Repeat this procedure if the lens cap becomes cross-threaded.
A daily inspection is recommended to check for any physical damage or abrasions to power
cord. Replace tubes and guards when necessary. Also check that UPLIGHT v2 is positioned
to maintain safe site conditions.
CLEANING
We recommend that you use only a damp cloth to clean your Uplight v2. Please note that
some chemicals used in cleaning agents may damage the diffuser and in no circumstances
should you use any such products.
SERVICE RECOMMENDATIONS
Only suitably qualified personnel should service the unit. If you have a problem with your unit
please return it to the outlet from where you purchased it, ensuring that you have full details
of your product as described on the product rating plate.
Should it be necessary for repairs to be undertaken, it is important to provide the suitably
qualified repairer with the complete unit.
Should you require service under the terms of our guarantee you will need to present
proof of purchase.
NOTE: Service repairers act on their own behalf and are not empowered to commit or legally
bind Birchwood Products Ltd, in any manner whatsoever.