Probuilt Professional Lighting Wobblelight 85w User Manual
Important safety instructions, Save these instructions

Manufactured by ProBuilt Professional Lighting: 877-707-0800
Thank you for purchasing Wobblelight
®
WL85F
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
QUESTIONS OR PROBLEMS?
Call ProBuilt Professional Lighting Customer Service and Technical Support at 877-707-0800 (Monday-Friday from 8:30 a.m. until 5 p.m. Central
time) or e-mail
This manual contains important safety and operating instructions for Wobblelight
®
WL85F portable lighting. Before using Wobblelight
®
WL85F please review all of
the following safety instructions carefully and read all labels on the Wobblelight
®
WL85F unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS:
WARNING: To reduce the risk of fire, electric shock, or injury to persons:
DO NOT connect Wobblelight
®
WL85F to power source until the bulb is installed and the unit is completely assembled.
DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight
®
WL85F unit is disconnected from the power source and the bulb
has completely cooled.
Not for use in wet locations. DO NOT use Wobblelight
®
WL85F where there is potential for exposure to excessive moisture from rain, snow, ice, water
spray or standing water.
Connect
Wobblelight
®
WL85F only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current
protection which is rated no higher than 15 amps. Any other connection voids warranty and may result in damage to the product, fire, property damage
and injury.
Keep away from flammable materials.
Wobblelight
®
WL85F must be operated in the upright position only. DO NOT mount Wobblelight
®
WL85F units upside down or restrain them such that
they lay on their side.
Use only approved extension cords in good condition and of the appropriate type, gauge and length.
Keep extensions cords dry and use ground fault circuit interrupter (GCFI) devices in accordance with all applicable electrical code requirements.