Probuilt Professional Lighting Uplight v2 - Manual (Page 4)

• If the unit is to be positioned horizontally on the ground ensure it does not pose a
trip hazard.
• If the Uplight v2 is to be used whilst propped against a vertical surface, ensure the unit is
positioned on its rubber base.
• If Uplight v2 is suspended only use the fixing point on the unit.
If the removable eyelets are used ensure they are connected to the correct anchorage
points and ensure nothing else is suspended on the unit.
• Ensure the mains cable does not present a trip hazard. Do not run cable across
walkways. Once the cable has been routed secure cable in position.
• Ensure the mains power cable is fully unwound before use.
• Do not remove plug from mains supply by pulling on power cord.
ELECTRICAL SAFETY GUIDELINES
PLEASE COMPLY WITH THE SPECIFIED ELECTRICAL REQUIREMENTS.
Power Supply Identification
The power supply of this UPLIGHT v2 unit is shown on the identification label and the rating
plate, which are found on the external packaging and the base of the unit respectively.
Model Numbers
110Volt
Uplight v2 2ft (18Watt) E712505
Uplight v2 4ft (36Watt) E712500