Poly-Tex PT-30 - Manual (Page 23)

RC1010
ROLL-UP TUBE CLIP 1.315" (2)
FT2070
ROLL-UP
CRANK RETAINER
RC1319
ROLL-UP CRANK (84")
WIGGLE WIRE HT1070
GABLE VENT ASSEMBLY
HT1062
ROLL-UP DR/VENT TUBE (42") WIGGLE WIRE BASE
RC1303
U-JOINT W/BOLTS
AD-130626
WIGGLE WIRE BASE
WIGGLE WIRE
GABLE VENT ASSEMBLY
HT1070
1. INSTALL WIGGLE WIRE BASE TO VENT OPENING WHERE SHOWN.
2. ATTACH HT1070 VENT ASSEMBLY PANEL TO END OF FIELDPRO ABOVE DOOR OPENING.
3. INSTALL WIGGLE WIRE ON SIDES, TOP AND BOTTOM.
4. TRIM HT1070 VENT ASSEMBLY PANEL TO APROXIMATE SIZE OF THE OPENING ABOVE THE DOOR.
5. SLIP HT1062 ROD END INTO POCKET.
6. CLIP ROLL-UP TUBE CLIP OVER ENDS OF POCKET ON HT1070 VENT ASSEMBLY OVER ROD.
7. ATTACH KNUCKLE RC1301 INTO ROD RC1319 AND TIGHTEN BOLTS.
8. ATTACH FT2070 ROLL-UP CRANK RETAINER ONTO DOOR VERTICAL APPROXIMATELY WHERE SHOWN
AND SET CRANK HANDLE INTO RETAINER.
TUBE CLIPS
RC1010
ROLL-UP CRANK
RC1319
U-JOINT W/BOLTS
RC1303
ROLL-UP DR/VENT TUBE (42")
HT1062
ROLL-UP CRANK RETAINER
FT2070
POCKET
VENT PARTS