Poly-Tex PT-30 - Manual (Page 17)

12"
60"
REV: AD-130626
SIDE RAIL
INSTRUCTIONS
1. ATTACH ROLL FORM RAILS TO FRAME ASSEMBLIES
WITH UNI-CLAMPS.
2. BOTTOM RAIL IS APPROXIMATELY 12" UP FROM BOTTOM
OF FRAME ASSEMBLY.
3. TOP RAIL IS 60" BETWEEN THE RAILS.
4. ATTACH WIGGLE WIRE BASE USING #12-14 x 1" SELF-
DRILLING SCREWS SPACED APPROXIMATELY 12" APART.
5. ATTACH SIDE RAIL WITH STOP TABS, LOCK WASHERS
AND HEX NUTS. SIDE RAIL IS 12" FROM INSIDE EDGE OF
CORNER HOOP.
6. INSTALL POLY ON 12" LOWER SECTION.
7. INSTALL POLY BETWEEN END FRAME AND SIDE RAILS.
8. INSTALL END FRAME POLY.
SIDE RAIL
SIDE POLY
LOWER POLY
12"
UNI-CLAMP
FT2108
#12-14 x 1" SELF
DRILLING SCREW
NB1809
UNI-CLAMP
#12-14 x 1" SELF
DRILLING SCREW
NB1809
VIEW FROM INSIDE OF STRUCTURE
5/16 WINGNUT NB1903