Otter Outdoors XT 650 Lodge - Manual (Page 7)

Page 7
13. Slide the tent over the main frame bar
assembly, then fasten the velcro straps
on the inside of the tent to each main
frame bar. Ref. Diagram 11.
Tent
Main Frame
Assembly
Diagram 11
14. The canvas tent (Item 2) has a plastic trim seal sewn into the edge, snap the plastic trim seal to the edge of the
sled (Item 1). Start at the front left corner and work your way around across the back and up the opposite side.
Ref. Diagram 12.
Optional: Secure with extra self-tapping screws if needed. See Detail A. Ref. Diagram 12.
Diagram 12
Back
Left Side
Front
Right Side
Line up seam on the corner
Left Side Back
1
2
Trim seal
Self-tapping screw
Note: Collapsing
the center and front
main frame poles
part way down
will make installation
easier.
Detail A
Optional Step
21