Otter Outdoors Pro XT 1200 Resort - Manual (Page 8)

Page 8
14. Slide the tent over the main frame bar
assembly, then fasten the velcro straps
on the inside of the tent to each main
frame bar. Ref. Diagram 11.
Tent
Main Frame
Assembly
Diagram 11
15. The canvas tent (Item 2) has a plastic trim seal sewn into the edge, snap the plastic trim seal to the edge of the
sled (Item 1). Start at the front left corner and work your way around across the back and up the opposite side.
Ref. Diagram 12.
Optional: Secure with extra self-tapping screws if needed. See Detail A. Ref. Diagram 12.
Diagram 12
Back
Left Side
Front
Right Side
Line up seam on the corner
Left Side Back
1
2
Note: Collapsing the center and
front main frame poles
part way down will make
installation easier.
Detail A
Trim seal
Self-tapping screw
Optional Step
22