Lincoln Electric IM10030 RANGER 3 PHASE - Manual (Page 8)

A-1 INSTALLATION
RANGER® 3 PhASE
A-1
TEChNICAL SPECIFICATIONS - RANGER® 3 PhASE ( K2337-3)
INPUT - GASOLINE ENGINE
RATED OUTPUT @ 104°F (40°C)- WELDER
RATED OUTPUT @ 104°F (40°C)- GENERATOR
Welding Output
DC Constant Current 225A/25V/40%
DC Constant Current 210A / 25V / 100%
DC Constant Voltage 200A / 20V / 100%
Auxiliary Power 1
11,500 Watts Preak, 10,000 Watts continuous 3 Phase 60Hz AC, 480V
9,000 Watts Continuous, 60 Hz AC
10,500 Watts Peak, 8500 Watts Continuous Single Phase 60 Hz AC
120/240 Volts
Make/Model
Kohler
CH23S
Description
2 cylinder
4 Cycle
Air-Cooled
Gasoline
Engine.
Aluminum Alloy
with Cast Iron
Liners,
Electronic
Ignition
Operating
Speed (RPM)
High Idle 3700
Full Load 3500
Low Idle 2200
Displacement
cu. in.
(cu.cm.)
41.1(674)
Capacities
Fuel:
12 Gal (45.4 L)
Lubricating Oil:
2.0 Qts. (1.9 L)
horsepower
23 HP @
3600 RPM
Starting
System
12VDC
Battery
Electric Start
Group 58
Battery
(435 cold
Cranking
Amps)
1 Output rating in watts is equivalent to volt - amperes at unity factor.Output voltage is within +/-10% at all loads up to rated capacity.
When welding available auxiliary power will be reduced.
RECEPTACLES
(2) 120VAC Duplex (5-20R)
(1) 120/240VAC Dual Voltage
Full KVA (14-50R)
(1) 480V AC (16-20R)
bATTERY ChARGING CIRCUIT bREAKER
20AMP for Engine Battery
Charging Circuit
AUXILIARY POWER CIRCUIT bREAKER
Two 20AMP for Two Duplex Receptacle
(2) 50AMP for Dual Voltage
(1) 15 AMP for 3 Phase (3 Pole)
RECEPTACLES AND CIRCUIT bREAKERS
hEIGhT WIDTh DEPTh WEIGhT
30.00** in. 21.50 in 42.25 in.
762.0 mm 546.0 mm 1073.0 mm
LUbRICATION VALVE LIFTERS FUEL SYSTEM GOVERNOR
Full Pressure Hydraulic Mechanical Fuel Pump with Mechanical Governor
with Full Flow Filter Additional electric fuel lift pump
5% Regulation on K2382-4.
AIR CLEANER ENGINE IDLER MUFFLER ENGINE PROTECTION
Low noise Muffler: Top outlet Shutdown on low oil
Dual Element Automatic Idler can be rotated. Made from pressure.
long life, aluminized steel.
PhYSICAL DIMENSIONS
ENGINE COMPONENTS
** Top of enclosure, add 6.00”(152mm) for exhaust.
514 lbs. (233kg)