Lincoln Electric IM10104 MAGNUM K3092-,K3093-,K3098-, K3130- PRO CURVE - Manual (Page 19)

D-4 MAINTENANCE D-4
MAGNUM ® PRO CURVE DUAL PROCEDURE & DUAL SCHEDULE
SWITCH WIRES
T0 RED LEAD
CABLE ASSEMBLY
STRAIN RELIEF
STRAIN RELIEF
HOUSING
CABLE BOOT
GUN TUBE
TRIGGER WIRES
GUN HOUSING
TRIGGER ASSEMBLY
TO BLUE LEAD
SWITCH
Figure E.5
For K3098 and K3130:
Connect the black lead and the white lead to the gun
trigger. Connect the other leads to the rocker switch
leads. (See Figure E.5).
j) Position the cable boot and strain relief on the cable
so it fits in cable handle cavity and lock the strain
relief in place by pushing the two halves together.
k) Assemble cable in left side of gun handle.
Assemble trigger into the proper handle cavity.(For
K3098 and K3130 also assemble the rocker switch
in the groves provided in the handle.) Assemble
right side of gun handle and tighten the screws that
hold the handle together. (See Figures E.4 and
E.5).
i) Install gun tube per Gun Tube and Nozzle section.
m) Install and trim liner per Liner Installation section.
WIRE FEEDER END REPAIR (K3092,
K3093, K3098 and K3130)
a) Remove the cable liner per previous instructions.
b) Remove the feeder end connector, molded gas
plug (or barbed fitting), cable handle nut, plastic
tailpiece, and connector cover (See Figure E.6).
NOTE: In order to remove the cable handle nut, the
tail of the connector cover must be depressed and the
cable handle nut rotated 1/4 turn counterclockwise as
viewed from the feeder end.
.43 (11 mm) MAX
CONNECTOR COVER PRESS HERE TO
REMOVE THE CABLE
HANDLE NUT
4.68 (119mm)
Figure E.6