Lincoln Electric IM10104 MAGNUM K3092-,K3093-,K3098-, K3130- PRO CURVE - Manual (Page 14)

B-4 INSTALLATION B-4
CONNECTION TO MILLER FEEDERS
Gun and cable assemblies which were assembled with a
K466-3 Connector Kit will connect easily to a variety of
popular Miller wire feeders.
a. Check that the gun liner, connector cap liner, drive
rolls and guide tubes are appropriate for the electrode
size being used.
b. Fully push the brass connector end of the gun and
cable into the connector receptacle on the outgoing
side of the feeder wire drive. Tighten the hand screw
to clamp down on the connector.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle.
CONNECTION TO HOBART SERIES 2000 FEEDERS
Gun cable assemblies which were assembled with a
K466-6, K466-7 or K466-9 Connection Kit will connect
easily to a feeder.
a. Check that the adapter and feeder outgoing guide, as
well as the drive roll, are appropriate for the electrode
size being used.
b. Fully push the brass connector end of the gun cable
into the outgoing side of the feeder wire drive. Secure
the cable using the hand screw on the wire feeder.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle.
CONNECTION TO LINCOLN 10 SERIES FEEDERS
Gun cable assemblies which were assembled with a
K466-10 Connection Kit or K471-21 thru -23 gun and
cable assemblies will connect easily to a 10 Series feed-
er.
a. Check that the K1500-2 gun adapter is in place on the
wire feeder. Check that the feeder guide tubes, as
well as the drive roll(s), are appropriate for the elec-
trode size being used.
b. Fully push the brass connector end of the gun cable
into the gun adapter on the outgoing side of the feed-
er wire drive and secure the cable using the hand
screw.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle.
MAGNUM ® PRO CURVE DUAL PROCEDURE & DUAL SCHEDULE