IEI Integration AUPS-C20 v1.01 - Manual (Page 42)

AUPS-C20 UPS Module
Page 34
4.3 Remote Control and Monitoring
The AUPS-C20 can be controlled (power on/off) and monitored the battery status through
a remote computer located in the same subnet with the AUPS-C20. To control and
monitor the AUPS-C20 remotely, follow the steps below.
Step 1: Connect the RJ-45 remote LAN connector on the I/O interface panel of the
AUPS-C20 (Figure 4-22) to a local area network connector.
Figure 4-22: RJ-45 Remote LAN Connector
Step 2: In a remote computer, install the IEI REMOTE AP. Double click the
AUPS_REMOTE_APv14 file in the x:\AUPS_REMOTE_APv14 directory.
Follow the steps to install the IEI REMOTE AP. After installation, launch the AP. If
there is a problem to launch the tool, execute the dotnetfxRedist20.exe first
(located in the same directory of the driver CD).
Step 3: The IEI REMOTE AP tool appears (Figure 4-23). All the AUPS-C20 modules in
the same subnet with this remote computer are shown in the list on the right.
Click the function buttons on the left to control the AUPS-C20.