IEI Integration RPC-6106_6108 - Manual (Page 54)

RPC-6106/6108 Rackmount LCD Workstation
Step 6: Remove the two internal retention screws that secure the PSU assembly to the
left side panel of the workstation (Figure 5-2).
Figure 5-2: PSU Internal Retention Screws
Step 7: Install the new PSU into the workstation making sure the PSU power connector
and PSU cooling fan are facing out of the workstation.
Step 8: Reinsert the two previously removed internal retention screws that secure the
PSU assembly to the left side panel of the workstation.
Step 9: Reinsert the four previously removed external retention screws that secure the
PSU assembly to the rear panel of the workstation.
Step 10: Close the back cover of the workstation and reinstall the workstation into the
cabinet or rack in which it was previously installed. Refer to Section 4.6 for
complete mounting instructions. Step 0:
5.6 System Fan Replacement
There are two 8 cm cooling fans inside the PAC-130G chassis. To replace the system fan,
please follow the instructions below.
Page 44