IEI Integration DM_Series v2.05 - Manual (Page 96)

DM Series Monitor
Page 82
7.1 Introduction
The touch panel controller enables analog resistive touch panels for four-wire, five-wire &
eight-wire models. The controller directly communicates with the PC system through the
touch panel communications interface. The controller design is superior in sensitivity,
accuracy, and friendly operation. The touch panel driver emulates the left mouse button
and the right mouse button functions.
The touch panel driver supports the following operating systems:
ƒ Microsoft ® Windows ® versions:
o Microsoft ® Windows ® 2000
o Microsoft ® Windows ® XP
o Microsoft ® Windows ® 2003
o Microsoft ® Windows ® 2008
o Microsoft ® Windows ® Vista
o Microsoft ® Windows ® 7
ƒ Microsoft ® Windows ® CE versions:
o Microsoft ® Windows ® CE 4.2
o Microsoft ® Windows ® CE 5.0
o Microsoft ® Windows ® CE 6.0
ƒ Linux Kernel 2.6
ƒ DOS
Driver installation is described below.
7.2 RS-232 or USB Touch Screen
Before installing the driver, connect the DM Series monitor to the motherboard. The DM
Series monitors support touch screen modality through an RS-232 or USB interface
connection. Decide through which interface the touch screen is to be controlled.
ƒ RS-232 Interface: If the touch screen interface connection is an RS-232
connection, connect the RS-232 connector on the single board computer to
the DB-9 connector of the DM Series monitor.