IEI Integration DM_Series v2.05 - Manual (Page 74)

DM Series Monitor
Page 60
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (
5
Figure 5-15 ).
5.5.1.2 DM-65 Panel Mounting
To mount the DM-65 monitor into a panel, follow steps one through three of the standard
panel mounting procedure (Section
5
5.5.1.1 ), then continue using the steps below.
Step 1: Cut out a section of the panel that corresponds to the rear panel dimensions of
the monitor.
Figure 5-16: DM-65 Panel Opening (Unit: mm)
Step 2: Secure the panel mounting clips to either side of the monitor using the retention
screws supplied in the mounting kit pack (
5
Figure 5-17 ).