IEI Integration AFL-056A-LX v2.10 - Manual (Page 47)

AFOLUX LX Panel PC
Page 34
Step 2: Once the mounting arm/stand has been firmly attached to the surface, lift the flat
panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The arm mount retention screw holes are shown in Figure 3-9.
Figure 3-9: Arm/Stand Mounting Retention Screw Holes
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel
PC. S te p 0 :
3.8 Bottom Panel Connectors
3.8.1 LAN Connection
There is one external RJ-45 LAN connector. The RJ-45 connector enables connection to
an external network. To connect a LAN cable with an RJ-45 connector, please follow the
instructions below.
Step 1: Locate the RJ-45 connector on the bottom panel of the AFOLUX LX.
Step 2: Align the connector. Align the RJ-45 connector on the LAN cable with the
RJ-45 connector on the bottom panel of the AFOLUX LX. See Figure 3-10.