IEI Integration AFL-056A-LX v2.10 - Manual (Page 45)

AFOLUX LX Panel PC
Page 32
than the overall size of the metal frame that surrounds the flat panel PC but just
large enough for the rear panel of the flat panel PC to fit through (Figure 3-7).
Figure 3-7: Panel Opening
Step 3: Slide the flat panel PC through the hole until the aluminum frame is flush against
the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 4 panel mounting
clamps on the AFOLUX LX.
Step 5: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel (Figure 3-8).
S te p 0 :