Figure 2-27: afl-w15a-n270 cutout – IEI Integration AFL-W19A_W19B_17D_W15A-N270 v2.20 User Manual

Page 49

AFL-W19A/W19B/17D/W15A-N270 Panel PC

Page 38

large enough for the rear panel of the flat panel PC to fit through. Recommended

cutout size shown below.

Figure 2-27: AFL-W15A-N270 Cutout

Step 3:

Slide the flat panel PC through the hole until the aluminum frame is flush against

the panel.

Step 4:

Insert the panel mounting clamps into the pre-formed holes along the edges of

the chassis, behind the aluminum frame.

Step 5:

Tighten the screws that pass through the panel mounting clamps until the plastic

caps at the front of all the screws are firmly secured to the panel.