2 stand mounting, 3 wall mounting – IEI Integration UPC-V312-D525 v1.02 User Manual

Page 42

UPC-V312-D525 Panel PC

Page 28

Step 4:

Secure the flat panel PC to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel PC.

Step 0:

3.6.2 Stand Mounting

The UPC-V312-D525 can be installed on any stand that supports the standard VESA

mounting interface. An example stand is shown below.

Figure 3-10: VESA Compliant Stand

To install the UPC-V312-D525 on the stand, follow the directions below.

Step 1:

Locate the screw holes on the rear of the UPC-V312-D525. This is where the

stand bracket will be attached. The stand mount retention screw holes are

Step 2:

Align the bracket with the screw holes.

Step 3:

Insert the retention screws into the screw holes to secure the bracket to the

UPC-V312-D525.

Step 0:

3.6.3 Wall Mounting

To mount the panel PC onto the wall, please follow the steps below.

Step 1:

Select the location on the wall for the wall-mounting bracket.

Step 2:

Carefully mark the locations of the four brackets screw holes on the wall.

Step 3:

Drill four pilot holes at the marked locations on the wall for the bracket retention

screws.