4 mounting the system with mounting brackets, Ounting the, Ystem with – IEI Integration TANK-101B-D525_N455 v1.10 User Manual

Page 27: Ounting, Rackets, Figure 3-4: hdd installation

TANK-101B/BW Embedded System

Page 16

Step 3:

Attach the HDD to the HDD bracket, and then slide the HDD to connect the HDD

to the SATA connector (Figure 3-4).

Figure 3-4: HDD Installation

Step 4:

Secure the HDD with the HDD bracket by four retention screws (Figure 3-4).

Step 5:

Reconnect the SATA signal and power cables to the TANK-101B/BW.

Step 6:

Reinstall the bottom panel.

3.4 Mounting the System with Mounting Brackets

To mount the embedded system onto a wall or some other surface using the two mounting

brackets, please follow the steps below.

Step 1:

Turn the embedded system over.

Step 2:

Align the two retention screw holes in each bracket with the corresponding

retention screw holes on the sides of the bottom surface.