IEI Integration IMBA-G410 v1.01 - Manual (Page 63)

2011/8/172011/8/17
IMBA-G410 ATX Motherboard
Page 49
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The IMBA-G410 includes some jumpers shown in Table 4-1.
Description Label Type
AT/ATX power select jumpers JAUTO1,
JAUTO2
2-pin header
Clear CMOS jumper JP1 3-pin header
COM2 function select jumper JP4 6-pin header
CompactFlash® setup JP2 2-pin header
CF voltage select jumper JP_CF1 3-pin header
USB power select jumpers USBPWR1,
USBPWR2
3-pin header
Table 4-1: Jumpers
4.4.1 AT/ATX Power Select Jumpers
Jumper Label: JAUTO1, JAUTO2
Jumper Type: 2-pin header
Jumper Settings: See Table 4-2