ZOLL M Series Defibrillator Rev H - Manual (Page 18)

OPTION INSERT
9650-0215-01 12-lead - 16
APPENDIX A
MODEM AND PHONE SETUP
The M Series with 12-Lead option may include a modem for transmitting 12-lead ECG information to remote
locations via landline or cellular phone. This section describes how to connect your M Series for phone
transmission.
Modem
• When included, the M Series with 12-Lead option ships with a cellular-ready PC card modem installed in the
upper PCMCIA slot (domestic units only).
• The
M Series with 12-Lead option is also available with an approved GSM card modem (obtained locally for
international customers).
Note: Only the upper PCMCIA slot supports modem communication. DO NOT attempt to insert the modem
into the lower slot.
Note: The M Series does not support all PCMCIA type modems. Contact ZOLL Technical Support before
attempting to use modems other than those supplied with the unit.
ZOLL Technical Support
Phone: (800) 348-9011
C
B
A
The modem can be removed for service or cleaning by removing screw B and sliding bezel A out of the PCMCIA
slot. The modem C is then removed by depressing the plunger to the right of the modem card until the modem
is free to slide out.
Cables
• Not all cell phones transmit ZOLL data reliably. See your local ZOLL Sales Representative for a list of ZOLL-
approved cell phones.
• A landline phone cable comes with modem equipped M Series units. This cable connects to the modem on
one end and plugs into a standard RJ-11 phone jack on the other end. The RJ-11 is compatible with POTS
(Plain Old Telephone System) phone lines such as those found in most residential homes or used for fax
machines.
• The modem in the M Series is compatible with certain AMPS (analog) or dual-mode cellular phones in the
U.S.A., and with certain GSM cellular phones in Europe, depending on modem model. Each model phone
M Series with Modem