ZOLL E Series Monitor Defibrillator Rev G NIBP - Manual (Page 17)

Specifications
9650-1214-01 Rev. G 17
Specifications
Principle of Operation Oscillometric
Warm-up Time Operational in less than 10 seconds
Regulatory Standards ANSI/AAMI SP10-2002;
EN 1060-1: 1996 Specification for Non-invasive sphygmomanometers;
EN 1060-3: 1997;
EN 60601-2-30: 2000
NIBP Measurement Range Systolic: 40 – 260 mmHg; 5.3 – 34.7 kPa
Diastolic: 20 – 200 mmHg; 2.7 – 26.7 kPa
Mean: 20 – 220 mmHg; 2.7 – 29.3 kPa
NIBP Measurement Accuracy Per AAMI SP10 +/- 5 mmHg (0.7 kPa) mean difference;
8 mmHg (1.1 kPa) standard deviation
a
NIBP Measurement Resolution 1 mmHg; 0.13 kPa
NIBP Measurement Cycle Time Typical: 30 seconds
Worst Case: 180 seconds
Pulse Rate Range
30 – 220 pulses per minute
Pulse Rate Resolution
1 bpm (beats per minute)
Alarm Limits Systolic:
High 80 – 260 mmHg
High 10.7 – 34.7 kPa
Diastolic:
High 50 – 200 mmHg
High 6.7 – 26.7 kPa
Mean:
High 60 – 220 mmHg
High 8.0 – 29.3 kPa
Low 40 – 140 mmHg
Low 5.3 – 18.7 kPa
Low 20 – 100 mmHg
Low 2.7 – 13.3 kPa
Low 20 – 120 mmHg
Low 2.7 – 16.0 kPa
Operating Time (with SpO
2
, EtCO
2
and NIBP options)
A new fully charged PD 4410 bat-
tery pack at 20º C (68º F):
• 35 defibrillator discharges at
maximum energy (200 J), or
• 1.25 hours minimum of
continuous ECG monitoring and
blood pressure measurements
once every 5 minutes, or
• 0.75 hours of continuous ECG
monitoring/pacing at 60 mA, 70
beats per minute.
For a new, fully charged lithium ion
battery pack at 20°C (68°F):
• 90 defibrillator discharges at
maximum energy (200 J), or
• 2.75 hours minimum of
continuous ECG monitoring and
blood pressure measurements
once every 5 minutes, or
• 2.25 hours of continuous ECG
monitoring/pacing at 60 mA, 70
beats per minute.