XLT XD-9006A (GAS Oven Version – C, AVI Hood Version – B) - Manual (Page 26)

26
Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
HOOD SERVICE PROCEDURES
Complete VFD manual available at www.xltovens.com
Hitachi X200 Restoring Factory Defaults
Access program parameters by pressing the key one time and using the up and down ar-
row keys to navigate to the appropriate parameter press the key again to make adjust-
ments to that parameter by using the up and down arrows. To store the new settings press the
button one time.
B031 = 01
B084 = 01
After pressing the key Press and hold the down arrow key and
Reset> key all at the same time. Release the keys all at once and the country code
should appear in the display (USA). Hitachi’s factory settings are now restored.
A001 = 01
A003 – USA = 60 Hz. World = 50 Hz.
A082 = Supply voltage at location 200, 215, or 230 choose appropriate voltage.
A093 = 3000
A094 = 01
A096 = 10
B002 = 25
C001 = 02
C002 = 03
C003 = 04
C004 = 05
C014 = 00
F001 = See Figure 1
H004 = 4
B031 = 03
Put controller into monitor mode by pressing the and holding until d001 appears on the
display release and then press the one time. The display should show 0.0.
Put the controller in Run mode by pressing the key one time. The Run indicator light lo-
cated next to the speed control knob should illuminate.
Test run the motor by turning on one of the oven/hood switches located on the face of the hood.