beautypg.com

White’s Electronics MXT Pro User Manual

Page 35

background image

adjustments. If you are unsure if a response is a

real target, and/or wish to sweep over any target

repeatedly, if is best to do so either holding in the

Trigger on the handgrip, or holding the GROUND

GRAB button. Squeezing and holding the trigger

on the grip or squeezing and holding the GROUND

GRAB button, temporarily disables tracking.

The 1st option a user should consider is the selec-

tion of an appropriate TRAC toggle setting for the

area. The Ground setting and Salt settings should

be almost self-explanatory. If you are searching in

typical ground, use the TRAC Ground setting.

If you are in a salt water or desert alkali ground

condition, use the TRAC Salt setting. When to use

the Lock setting can be less obvious. If it seems

like something is wrong with the detector, wildly

fluctuating Threshold hum (only during search coil

passes), try the Lock setting. Before switching to

the Lock setting, be sure to pump the search coil up

and down over the ground a few times in the TRAC

Ground or Salt setting to insure that you have

achieved proper ground balance for that area. If

the detector smooths out and starts operating more

predictably in Lock, you made the correct choice.

If there isn’t any change, you may need to return

to the Ground or Salt setting and either reduce the

Gain control counterclockwise and/or increase the

Dual control (SAT) clockwise and try again. An

area littered with man-made iron would dictate the

Lock setting. On the other hand an area with very

inconsistent ground would not, such an area would

dictate Reduced Gain and/or higher SAT settings.

The 2nd option is Gain. Some areas require, and

some operators just prefer, the more predictable

operation normal “P” or reduced Gain settings

provide. Others prefer to push Gain to the limits of

their patience to find the deepest targets. There is a

point of diminishing returns either indicated by the

OVERLOAD display telling you to lift the loop due

to a Gain setting to high for the ground, or a user

missing targets because they can not sort them

from sporadic noise experienced at high Gain.

The 3rd option goes hand in hand with the Gain

setting and the SAT speed or level controlled by

the DUAL CONTROL. Higher (faster) SAT speeds

are more user friendly, however, may compromise

some sensitivity particularly to small nuggets

as well as adding additional search coil sweep

requirements. On the other hand faster SAT will

allow for higher Gain settings and more incon-

sistent ground conditions. A balancing act must

be achieved between the Gain control and SAT

speed that provides both good performance and

enough stability to recognize nuggets from ground

or external noise. A new SAT feature “Hyper SAT”,

provides for the most extreme conditions with very

unique characteristics.

The 4th option is Threshold level. It is best to

search with a continuous hum or threshold (edge

of sound). You can hear smaller and/or deeper

nuggets and be made aware when the SAT speed

is doing its job maintaining the Threshold hum. It,

however, also requires more patience and con-

centration. Finding the Threshold, and then setting

the Threshold just counterclockwise of it, provides

good performance for those who cannot tolerate

the continuous Threshold hum.

The 5th option is if you prefer the distinctive grunt

on iron, or the same VCO audio tone for all targets.

Pressing “Music Notes” Tone ID, the Iron Grunt

feature can be turned on/off. When on, targets

certain to be iron will produce a unique grunt audio.

When off, all targets sound with the standard VCO

audio.

Chapter MXT Pro Searching