Installation, Connection, Mounting diagram – Warner Electric CBC-100 User Manual
Page 2: Dimensions
2
Warner Electric • 800-234-3369
P-266
•
819-0472
Installation
To avoid injury (or even death),
always make certain all power is off before
attempting to install this control or any electrical
equipment.
1. Conduit Box Mount
a. Mount the conduit box to the magnet
assembly per the instructions found in the
manual shipped with the clutch or brake.
b. Connect wires to the power source, switching,
and magnet coil per the Connection diagram
and the following instructions:
1. Connect the red wire to one of the magnet
terminals.
2. Connect the red/white stripe wire to the
other magnet terminal.
3. Connect the hot side of the power source
to the black/red wire through the fuse and
switch as shown.
4. Connect the neutral side (other hot side for
the CBC-100-2) to the white wire.
c. Attach the cover with the CBC-100 to the
conduit box.
2. Panel Mount
a. Mount the CBC-100 in a convenient location in
the conrol panel using the Dimensions dia-
gram. NOTE: A barrier strip or terminal strip is
recommended for wiring between the CBC-
100 and the external connections to the brake
or clutch, switch, fuse, and power source.
b. Connect the power source, switching, and
magnet coil per the Connection diagram and
the following instructions:
1. Connect the red wire to one of the magnet
terminals.
2. Connect red/white strip wire to the other
magnet terminal.
3. Connect the hot side of the power source
to the black/red wire through the fuse and
switch as shown.
4. Connect the neutral side (other hot side for
the CBC-100-2) to the white wire.
This is a floating-type power supply
and is not referenced to AC ground. Under no
circumstances should any of the output wire leads
be connected to earth or chassis ground as the unit
will be destroyed.
Connection
FUSE
SWITCH
BLACK/
RED
HOT
CBC-100-1
120 VAC
CBC-100-2
220/240 VAC
NEUTRAL
USER FURNISHED
WHITE
CBC-100
RED
RED/WHITE
90
VOLT
Mounting Diagram
2.18"
(55.4)
1.34"
(34.0) MAX.
0.166" (4.2) DIA.
MOUNTING HOLE
FOR #6 SCREW
0.625"
(15.9)
0.625"
(15.9)
MAX.
Dimensions
BLACK/RED
WHITE
RED
RED/WHITE
CBC-100