Vanguard PCI-600 - Manual (Page 13)

REV 2 PCI-600 USER’S MANUAL
10
d. From the "Timer Stop" section on the control panel, press the [→] key until "DRY
CONTACT" is selected as shown below:
e. Press and hold the
[↓]
key to momentarily turn on the current source:
f. Turn the [CONTROL KNOB] clockwise to set the desired current. The screen will be
updated as shown below:
g. Release the [↓] key.
h. Press the
[↑]
key to select "ON + TMR" mode and start the test:
i. The PCI-600 will inject the preset current into the bus and turn on the timer. The LCD
will be updated as shown below:
j. The timer will stop and the current source will turn off when the PCI-600 "TIMER STOP"
input detects a change in the relay dry contact, or if the operator presses the [↓] key
to select the "OFF" mode.
986mS 59.2CY
Ext I: +0.000 A
Drv I: 20.00 A
0mS 0.0CY
Ext I: -0.000 A
Drv I: 20.00 A