Vanguard EZCT-S2A User Manual

Page 21

REV 1 EZCT S2A USER’S MANUAL

When pressing a key, the corresponding number on the key will be displayed first.
Pressing the key again will display the first letter on the key. Pressing the key again will
display the second letter on the key. For example, to type the letter “A”, you must press
the

[2]

key twice. To erase the character at the cursor position, press the

[CLEAR]

key.

Press the

[PAPER ∧ Contrast]

button to move to the next character. Press the

[PAPER ∨ Contrast]

key to move to the previous character. Press the

[ENTER]

key

when you are done typing the note.

i. The following screen will be displayed:

Press the

[START]

key to begin running the test.

j. If the selected test included an excitation test, the following screen will be displayed:

NOTE

The “HIGH VOLTAGE PRESENT” light will be illuminated to indicate that high
voltage is present.

k. If the selected test included a ratio test, the following screen will be displayed:

RATIO TEST

Vx = 39.9 Vh = 0.4984
I = 0.1324 RAT=+80.058

CABLES ENERGIZED!
1500V

1.0A

x1-x2

I = 0.6810 AMPS
V = 61.0 VAC

TEST 1 parameters:
1500V

1.0A

x1-x2

"START" to begin