Auto-ohm operating procedures – Vanguard Auto-Ohm User Manual
Page 16
Auto-Ohm Operating Procedures
12
a. Press control knob to select this mode.
The user now can select any of the last three
reading to be displayed. To select the
reading, turn the control knob to one of the
menus.
Figure 24. Select Reading Menus
b. When one of the prompts above displays,
press the control knob to display reading.
Figure 25. Test Record Readout
c. The above display shows the recorded
test resistance (120.2 Micro-ohms) and the
test current level (100 amps) at which it was
measured. When the displayed record of
resistance is reviewed and noted, press the
control knob to return to the Main Menu.
This ends the PREVIOUS RESULTS
procedure.
This concludes the operating procedures for
all Auto-Ohm functions.
PREVIOUS RESULTS
I= 100AMPS
120.2 MICRO-OHM
PREVIOUS RESULTS
PREVIOUS RESULTS
- Resistor Transducer Adapter 9095-UC (7 pages)
- Accu-Ohm 200 S2 (4 pages)
- Accu-Trans (28 pages)
- ATO-400 (43 pages)
- ATO-400P (44 pages)
- Auto-Ohm 100_200 s2 (31 pages)
- Auto‐Ohm 200 S3 (66 pages)
- DMOM-100 (35 pages)
- DMOM-100_200 s2 (42 pages)
- DMOM-200 (33 pages)
- Herculito (17 pages)
- ATRT-01 S2 (59 pages)
- ATRT-01_01B S3 (88 pages)
- ATRT-01_01B_01D (31 pages)
- ATRT-03_03A (114 pages)
- ATRT-03_03A S2 (147 pages)
- CVT-765 (46 pages)
- Tri-Phase (155 pages)
- CBCT (14 pages)
- CBPS-300 (16 pages)
- CT-3500 (24 pages)
- CT-3500 S2 (53 pages)
- CT-6500 (69 pages)
- CT-6500 S2 (82 pages)
- CT-7000 (83 pages)
- CT-7000 S2 (108 pages)
- CT-7000 S3 (137 pages)
- CT-7500 (76 pages)
- CT-7500 S2 (110 pages)
- CT-8000 (120 pages)
- CT-8000 S3 (145 pages)
- DigiTMR (86 pages)
- DigiTMR S2 (123 pages)
- DigiTMR S2 PC (31 pages)
- MCCB-250 (17 pages)
- UPS S2 (13 pages)
- EZCT-2000 (68 pages)
- EZCT-2000 (45 pages)
- EZCT-2000A (103 pages)
- EZCT-2000B (118 pages)
- EZCT-2000C Plus (119 pages)
- EZCT-S2 (66 pages)
- EZCT-S2A (98 pages)
- IRM-5000P (58 pages)