TREND IQVIEW_NDP - Manual (Page 2)

2 IQVIEW/NPD ADAPTOR PLATE Installation Instructions TG200828 Issue 1/A 24/11/04
IQVIEW/NDP ADAPTOR PLATE Installation Instructions
Trend Control Systems Ltd reserves the right to revise this publication from time to time and make changes to the content
hereof without obligation to notify any person of such revisions or changes.
Website www.trend-controls.com
Telephone +44 (0)1403 211888
P.O. Box 34, Horsham, West Sussex, RH12 2YF United Kingdom
Fax (International) +44 (0)1403 210982
E-mail [email protected] Registered office. Novar House 24 Queens Road Weybridge Surrey KT13 9UX Registered in England No 1664519
Fax (UK) +44 (0)1403 241608
3 2 1
1
LINK RS232 Rx Tx OK 28-36 V
24 V ETHERNET OK
DATA R+ R- T+ T-
7 6 5 4
Installation
(continued)
Mount Adaptor Plate 4
crinkle washer
(supplied)
4 mm nut
(supplied)
Fit IQView to Adaptor Plate 5
a
b
c
view from rear
view from front
4 x M4 x 10 mm
s c r e w s
provided
!
WARNING
Do not use any other screws than those
provided. Failure to comply could cause
damage to the unit
view from front
6 mm (0.24”)
maximum
spare screws available: ACC/SCREWS
Install IQView 7
IQView../RPM Installation
Instructions TG200712
a
view from front
b
view from rear
tighten 4 off 4 mm nuts
3 mm
hexagonal
socket key
Earth Adapter Plate 6
28 - 36 V
24 V ~
24 Vac
24 Vac
E
28 Vdc
+28V 0V
E
rear view of
connector
~
WEEE Directive :
At the end of their useful life the packaging and
product should be disposed of via a suitable
recycling centre.
Do not dispose of with normal household waste.
Do not burn.