TREND TMNE, G, H - Manual (Page 8)

8 TMNE, G, H Trend Modem Node Controller Installation Instructions TG200730 Issue 3, 08/01/2009
TMNE, G, H Installation Instructions
1.4 Installation - Configuration
(continued)
J 7
E T 1
J 1 6
D e v B
J 1 5
D e v A
Close Panel
13
X Q
TMN
T M N
e.g.
F
select deFault module
• Use WupDn or PowerTool
• If on Lan or direct connected set Lan x, address = switch
setting.
• If on Internetwork set Lan = switch setting and address =
switch setting.
top Menu :
Status Record List Delaylist deFault Help eXit
(Direct connection see 1.4 step 12)
or
Autodialling Manual,
90-1353
TMNE, G, H Data Sheet,
TA200734
to eXit module having
changed parameter to Quit module and
discard changes
Note that a PIN may be required to make changes in configuration mode. If the PIN has been forgotton the user should contact
Technical Support quoting the default generator number (Default module) whereupon a default PIN will be supplied. This will only
work during the same configuration mode session i.e. the utility must not be exited between reading the generator and entering
the default PIN. After the PIN is entered a new PIN should be set up and remembered.
14
Configure
822Toolbox/921 only
Connect Local PC
12
9 Way D type
Female
J15/J4
1
J7
ET1
J16
Dev B
J15
Dev A
J15 (TMNE)
J4 (TMNH,
TMNG) WupDn or PowerTool
(not 962, 963 or 945)
25 Way D type Male
CABLE/58-0750