TREND PACK_LNC2_STD - Manual

PACK/LNC2/STD Installation Instructions TG200240 Issue 3 09/07/08 1
Installation Instructions
PACK/LNC2/STD
Lancard Node Controller
Important: Retain these instructions
3 Installation
1 Unpacking
Installation
Instructions
TG200240
Dimensions
1
WARNING: Opening the panel may
expose dangerous
voltages.
417-IEC-5036
Caution: The LNC2 contains static
sensitive devices. Suitable
anti-static precautions
should be taken throughout
this operation to prevent
damage to the unit.
BS EN100015/1 Basic Specification:
protection of electrostatic sensitive
devices.
LA
N
T
X
LA
N
R
X
LA
N B
U S
Y
P C
B
U S
Y
L A N O K
L A N
S W 1 S W 2
R S 2 3 2
L O N
L O N
O K
S E R V I C E
L A N O K
L N C 2
L A N
180 mm (7.09”)
22 mm (0.87”)
127 mm (5”)
80 mm (3.15”)
27 mm
(1.06”)
80 mm (3.15”)
350 mm (13.78”)
Note that order code for full product is PACK/LNC2/STD. Code LNC2 is replacement board only.
2 Storage
H O
2
-10 °C
(14 °F) +70 °C
(158 °F) 0 %RH 95 %RH
It is recommended that the installation
should comply with the HSE
Memorandum of Guidance on
Electricity at Work Regulations 1989.
For USA install equipment in accordance
with the National Electric Code.
2 m (6’ 6.74”)
16 mm (0.63”)