Alto-Shaam ASC-4G User Manual
Page 5
A S C - 4 G G a s C o n v e c t i o n O v e n - E l e c t r o n i c C o n t r o l • 3
I N S T A L L A T I O N
The Alto-Shaam convection
oven must be installed in a
location that will permit the
oven to function for its
intended purpose and to
allow adequate clearance for
ventilation, proper cleaning,
and maintenance.
1. Hood installation is
required. (
CHECK
LOCAL CODES
.)
2. The oven must be installed on a stable and
level surface. A non-combustible, heat
resistant, and fireproof surface is highly
recommended. If the oven is to be installed
on a combustible surface, factory supplied legs
or oven stand MUST be used.
3. DO NOT install this oven in any area where it
may be affected by any adverse conditions such
as steam, grease, dripping water, high
temperatures, etc.
4. This appliance must be kept free and clear of
any combustible materials.
5. This appliance must be kept free and clear of
any obstructions blocking access for
maintenance or service.
W E I G H T
NET
393 lb
(178 kg)
SHIPPING
438 lb
(199 kg)
CRATE
40" H
X
44" W
X
53" D
DI M E N SI O N S
:
(1016mm x 1118mm x 1346mm)
MINIMUM ENTRY CLEARANCE
31-1/2" (800mm)
UNCRATED
®
D I M E N S I O N S
H x W x D:
EXTERIOR
:
58-1/2" x 38" x 44-1/2"
(1486mm x 964mm x 1130mm)
INTERIOR
:
24" x 29-1/8" x 25"
(610mm x 740mm x 635mm)
MINIMUM CLEARANCE REQUIREMENTS
COMBUSTIBLE
NON
-
COMBUSTIBLE
SURFACES
SURFACES
BACK
0" (0mm)
0" ( 0mm)
LEFT SIDE
2" (51mm)
0" ( 0mm)
RIGHT SIDE
2" (51mm)
2" (51mm)
FROM GREASE PRODUCING EQUIPMENT
6" (152mm)
6" (152mm)
E N T RY C L E A R A N C E
:
31-1/2" (800mm)
UNCRATED
R E C O M M E N D E D S E RV I C E A C C E S S
:
20" (508mm)
RIGHT
CONTROL SIDE
D A N G E R
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
C A U T I O N
DO NOT LIFT OR MOVE THE
OVEN BY USING THE DOORS
OR THE DOOR HANDLES.
C A U T I O N
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
D A N G E R
DO NOT store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.
S I T E I N S T A L L A T I O N