Terk HDTVO_OMЙ - Manual (Page 14)

12
To mount the HDTVo on a rafter located in an attic where the roof
has 0-45 degree pitch (see fig. 6):
1. Locate the HDTVo antenna and all included components.
2. Using the four lag screws, attach the mini-mast bracket to the
rafter. Be sure to position the bracket vertically on the rafter.
3. Slide the straight end of the mini-mast into the mini-mast
bracket, and using the two nuts and the two bolts, secure
the mini-mast to the mini-mast bracket. Be sure to orient the
mini-mast as shown in the illustration.
4. Using the four 1.75” threaded bolts, the four washers and the
four 1.75” nuts, attach the antenna bracket and the pole clamp
to the strait segment of the mini-mast that’s adjacent to where
the mini-mast begins to curve.
5. Gently spread open the antenna’s two side reception elements.
6. Slide the back of the antenna into the antenna bracket.
7. Insert the 3” partially threaded bolt into the hole on the top of
the antenna bracket, and partially tighten the bolt.
8. With the 3” partially threaded bolt only partially tightened,
adjust the antenna so that it is precisely pointing towards the
broadcast tower (see “Positioning the HDTVo”).
9. Tighten the 3” partially threaded bolt, securing the antenna
in the antenna bracket.
10. Skip to the “Connecting the HDTVo to a TV” section to
complete installation.
HD
TV
o
Fig 6.